Why am I getting feedback noise when trying to calibrate speakers?

If you are getting feedback noise during speaker measurements with the Reference 4 Measure app, this guide will provide more details on the issue and tips on resolving it.


Before starting your measurements with the Reference 4 Measure app, it is important to make sure that your microphone input isn't routed directly to the audio device outputs, bypassing the computer, or in other words, that the direct monitoring is not enabled on your audio interface. 

 

What is direct monitoring?

Direct monitoring takes the input signal from the audio interface and sends it straight to the line and headphone outputs on the audio device. This is great for monitoring the input signal with near-zero latency. If you, however, wish to apply effects on your input signal via your DAW or calibrate your speakers using Reference 4 Measure software, you will need to use the normal 'input monitoring' (also called software or DAW monitoring). 

 

Direct signal is not converted from analog to digital and is not processed by the computer which is essential for the Measure software to make calculations when correcting the frequency response of your speakers in your room. Since the processing of the signal via the computer will take more time it will be slightly delayed and when mixed with the direct signal this is what can cause phasing issues and/or feedback. 

 

How to disable direct monitoring? 

A lot of audio interfaces will have a button or a switch on the device to disable direct monitoring. 

 

mceclip0.png

 

A rotary knob can sometimes also be used to dial in the amount of the software processed signal versus the direct signal. In that case, the knob needs to be set 100% to software monitoring (marked 'USB' in the image below) to be used with Measure software.  mceclip1.png

If an audio interface doesn't have a button or a knob on the device to control direct monitoring, it can also be controlled via app/control software. Usually just muting the input channel for the microphone will do the trick but there are some devices where this will also mute the software/DAW monitoring so alternatively, just moving the microphone input channel's fader down to infinity will disable the direct monitoring as well. 

   mceclip2.png

Was this article helpful?

32 out of 89 found this helpful

Have more questions? Submit a request

4 comments

0

Hi Evan, 

If the mic signal is touted directly to your speakers (direct monitoring), this will cause a feedback loop making it impossible to take measurements. You can turn off direct monitoring in your interface routing software by turning the mic level down or muting it, but you might also have a physical Direct Monitoring button on your interface. 

The mic will still be feeding the measurement signals into the Measure app, but not directly outputting to speakers. To put it simply, you shouldn't be hearing anything from the speakers if you tap on the mic or talk into it. Many thanks!

0

What is direct monitoring on Apollo twin?

0

Can you elaborate on this please? I am using Focusrite Clarett 2Pre and I get feedback when using the mic and setting up my system for calibration.

 

0

This UAD forum thread should provide instructions on how to disable direct monitoring -
https://uadforum.com/support-troubleshooting/27968-how-do-i-turn-direct-monitoring-off.html

Please sign in to leave a comment.